Article Open Access

Finite Element Analysis of Strength Degradation and Interface Behavior Controlling Bund Wall Stability in an Ex-Mining Pit

Revia Oktaviani, Tommy Trides, Albertus Juvensius Pontus, Afdal Jamil Tanjung, Haviluddin Haviluddin

Abstract


This study presents a finite element analysis of the stability and interface behavior of a bund wall constructed under tropical mining conditions at the Banda Mine, East Kalimantan, Indonesia. The research aims to evaluate the effects of strength degradation and geometric interfaces on the overall stability of the embankment system, which was designed to retain overburden material and mitigate slope failure under combined rainfall and seismic loading. The bund wall, with an overall height of 75 m and a base width of 130 m, was constructed using compacted sandy loam sourced from site overburden. Laboratory testing determined the geotechnical parameters of the materials, including soft clay, sandy loam, and siltstone foundation. Finite element modeling was performed on six critical cross sections to simulate progressive strength reduction representing 0%, 25%, and 50% cohesion loss. The calculated factors of safety ranged from 1.87 to 2.55 along the slope, 3.40 to 5.81 at the bund wall base, and 7.79 to 10.27 within the foundation, confirming overall structural stability under all modeled scenarios. However, local reductions in stability were observed near the interface zones and the central section of the wall at depths exceeding 25 m. These findings highlight the influence of interface geometry and strength degradation on stability performance and emphasize the need for improved compaction and continuous stress monitoring during operation


Keywords


In-Pit Dump, Bund Wall, Finite Element Analysis, Strength Degradation, Interface Behavior

References


B. H. G. Brady and E. T. Brown, Rock Mechanics for Underground Mining. Springer, 2006.

X. Guo, Y. Wang, Y. Jiang, and Q. Liu, "Failure mechanism of soil slopes under heavy rainfall in tropical and subtropical regions," Catena, vol. 200, Art. no. 105151, 2021.

M. Zhang, H. Cheng, W. Wang, and R. Wei, "Probabilistic stability assessment of retaining structures in tropical residual soil under varied rainfall infiltration," Soils Found., vol. 64, no. 1, Art. no. 101416, 2024.

D. Li, G. Chen, Q. Xu, and L. Zhang, "Three-dimensional numerical analysis of dump slope stability in large open-pit mines," Int. J. Min. Sci. Technol., vol. 31, no. 2, pp. 183–193, 2021.

J. Luo, C. Zhang, S. Li, and H. Li, "Stability evaluation of earth dams with curved alignment using the strength reduction finite element method," Comput. Geotech., vol. 146, Art. no. 104710, 2022.

X. Zhang, Y. Wang, L. Zhang, and Z. Li, "Stability analysis of high and steep slopes under rainfall and seismic conditions: A comparative study of LEM and FEM," Eng. Geol., vol. 314, Art. no. 107000, 2023.

H. Sun, H. Yang, B. Xu, and Z. Zhang, "Time-dependent stability analysis of high-plasticity clay slopes considering rainfall infiltration and softening," Geosciences, vol. 13, no. 11, Art. no. 327, 2023.

J. Huang, X. Li, Y. Wang, and R. Wei, "A new strength reduction method for slope stability analysis based on the stress state variable," Int. J. Numer. Anal. Methods Geomech., vol. 46, no. 9, pp. 1659–1678, 2022.

Y. Jian and T. Deng, "Comparative study on stability of tailings dam slopes based on limit equilibrium and finite element methods," J. Geotech. Geoenviron. Eng., vol. 150, no. 4, Art. no. 04024003, 2024.

B. Situmorang and F. Burhan, Peta Geologi Lembar Tanjung Redeb. Bandung, Indonesia: Pusat Survei Geologi, 2011.

E. M. Dawson, W. H. Roth, and A. Drescher, "Slope stability analysis by strength reduction," Géotechnique, vol. 49, no. 6, pp. 835–840, 1999.

D. V. Griffiths and P. A. Lane, "Slope stability analysis by finite elements," Géotechnique, vol. 49, no. 3, pp. 387–403, 1999.

S. Gao, J. Zhang, and Y. Li, "Seismic stability analysis of a high mine dump considering the effect of pore water pressure," J. Rock Mech. Geotech. Eng., vol. 12, no. 5, pp. 1004–1015, 2020.

Transportation Research Board, Seismic Analysis and Design of Retaining Walls, Buried Structures, Slopes, and Embankments – Volume 1, NCHRP Report 611, Washington, D.C., USA, 2008.

D. C. Wyllie and C. W. Mah, Rock Slope Engineering: Civil and Mining, 4th ed. London, UK: Spon Press, 2004.

J. R. Pérez-López and J. Garzón-Roca, "Advanced stability analysis of mining waste dumps incorporating real-time hydrological data," Minerals, vol. 12, no. 8, Art. no. 953, 2022.

K. Yang, M. Deng, and W. Wang, "Stability analysis of slopes with complex structures using the numerical manifold method," Rock Mech. Rock Eng., vol. 57, pp. 2099–2118, 2024.

Z. T. Bieniawski, Engineering Rock Mass Classifications: A Complete Manual for Engineers and Geologists in Mining, Civil, and Petroleum Engineering. New York, NY, USA: John Wiley & Sons, Inc., 1989.

A. Palmström and E. Broch, "Use and misuse of rock mass classification systems with particular reference to the Q-system," Tunn. Undergr. Space Technol., vol. 21, no. 6, pp. 575–593, 2006.

ISRM, Rock Characterization, Testing and Monitoring: ISRM Suggested Methods, E. T. Brown, Ed. Oxford, UK: Pergamon Press, 1981.

E. Hoek and E. T. Brown, "Practical estimates of rock mass strength," Int. J. Rock Mech. Min. Sci., vol. 34, no. 8, pp. 1165–1186, 1997.

ASTM, Standard Test Methods for Liquid Limit, Plastic Limit, and Plasticity Index of Soils, ASTM Standard D4318, ASTM International, West Conshohocken, PA, 2017.

B. M. Das, Principles of Geotechnical Engineering, 6th ed. Stamford, CT, USA: Cengage Learning, 2007.

R. D. Holtz, W. D. Kovacs, and T. C. Sheahan, An Introduction to Geotechnical Engineering, 2nd ed. Upper Saddle River, NJ, USA: Pearson, 2011.

A. W. Skempton, "The colloidal activity of clays," Géotechnique, vol. 3, no. 1, pp. 30–53, 1953.

J. K. Mitchell and K. Soga, Fundamentals of Soil Behavior, 3rd ed. Hoboken, NJ, USA: John Wiley & Sons, Inc., 2005.

H. B. Seed, R. J. Woodward, and R. Lundgren, "Prediction of swelling potential for compacted clays," J. Soil Mech. Found. Div., vol. 88, no. 3, pp. 53–87, 1962.

J. M. Duncan, S. G. Wright, and T. L. Brandon, Soil Strength and Slope Stability, 2nd ed. Hoboken, NJ, USA: John Wiley & Sons, Inc., 2014.

E. Hoek and J. W. Bray, Rock Slope Engineering, 3rd ed. London, UK: The Institution of Mining and Metallurgy, 1981.

S. Chen, Y. Li, and G. Wang, "Numerical modeling of embankment failure due to basal sliding on soft clay foundations," Can. Geotech. J., vol. 60, no. 11, pp. 1662–1678, 2023.




DOI: https://doi.org/10.52088/ijesty.v6i1.1786

Refbacks

  • There are currently no refbacks.


Copyright (c) 2026 Revia Oktaviani, Tommy Trides, Albertus Juvensius Pontus, Afdal Jamil Tanjung, Haviluddin Haviluddin

International Journal of Engineering, Science, and Information Technology (IJESTY) eISSN 2775-2674