Effect of Changes in Air Temperature on Fuel Consumption and HC and Co Exhaust Gas Emissions

Resep Sembiring, Immanuel Munthe, Adnan Surbakti, Tinus Ginting, Sabar Pasaribu

Abstract


Motorized vehicles are generally equipped with a driving engine which functions as a driver for the car. Motorized vehicles have engines consisting of one cylinder, two cylinders, three cylinders, and so on, and all of them require air as a medium for burning fuel in the combustion chamber to produce power to drive the vehicle. Motorized vehicles, both at sea and on land, operate at different air temperatures in all corners of the earth. This research was carried out by varying the air temperature entering the combustion chamber. The intended temperatures are 20oC, 25oC, 30oC, 35oC, and 40oC, and what will be examined is fuel consumption, HC, and CO exhaust emissions. The research results show that air temperatures from 20 to 40 degrees do not significantly affect fuel consumption or HC and CO exhaust emissions.


Keywords


Air Temperature, Exhaust Emissions, Fuel, Gas Emissions

Full Text:

PDF

References


H. Ardianto, N. D. Prasetyawati, and S. Sudaryanto, “DISTRIBUTION OF MOTOR VEHICLE VOLUMES AND AMBIENT AIR DUST LEVELS IN HOT POINTS OF YOGYAKARTA CITY, INDONESIA,” J. Kesehat. Lingkung., vol. 16, no. 1, 2024, doi: 10.20473/jkl.v16i1.2024.76-88.

S. Muniruzzaman, M. Orvin, S. Wasif, S. Nasrin, and M. Hadiuzzman, “Investigating Network Efficiency Improvement Measures Using Simulation Technique in Mirpur Area,” Int. J. Traffic Transp. Eng., vol. 8, no. 1, 2019.

W. A. Fanny, S. Subagjo, and T. Prakoso, “Pengembangan katalis Kalsium Oksida untuk sintesis biodiesel,” J. Tek. Kim. Indones., vol. 11, no. 2, p. 66, 2018, doi: 10.5614/jtki.2012.11.2.1.

L. Yang, Q. Wang, X. Bai, J. Deng, and Y. Hu, “Mapping of trace elements in coal and ash research based on a bibliometric analysis method spanning 1971–2017,” Minerals, vol. 8, no. 3, 2018, doi: 10.3390/min8030089.

O. Apata and D. T. O. Oyedokun, “An overview of control techniques for wind turbine systems,” Scientific African, vol. 10. 2020, doi: 10.1016/j.sciaf.2020.e00566.

K. D. Von Ellenrieder and K. P. Parker, “40th AIAA Aerospace Sciences Meeting and Exhibit Flow Behind Oscillating Foils,” Aerospace, 2002.

N. Abdull, M. Yoneda, and Y. Shimada, “Traffic characteristics and pollutant emission from road transport in urban area,” Air Qual. Atmos. Heal., vol. 13, no. 6, 2020, doi: 10.1007/s11869-020-00830-w.

J. S. Pasaribu and A. Tamami, “Analysis of the Web Development of Piksi Ganesha Polytechnic Campus Students With the Integration of the MBKM Program Menu in the Student Information System Project,” Int. J. Eng. Sci. Inf. Technol., vol. 4, no. 3, pp. 28–34, 2024, doi: 10.52088/ijesty.v4i3.520.

B. N. Boots and A. Getls, “Point pattern analysis,” 2020.

Y. C. Wulan, Y. Yasmi, C. Purba, and E. Wollenberg, Analisa Konflik Sektor Kehutanan di Indonesia 1997 - 2003. Bogor, Indonesia: Center for International Forestry Research, 2004.

W. Rasheed and A. Jeyakumar, “Magnitude and severity of anthropometric failure among children under two years using Composite Index of Anthropometric Failure (CIAF) and WHO standards,” Int. J. Pediatr. Adolesc. Med., vol. 5, no. 1, pp. 24–27, 2018, doi: 10.1016/j.ijpam.2017.12.003.

a R. Jenkins, C. S. Van Rooyen, J. J. Smallie, J. a Harrison, M. Diamond, and H. a Smit, “Best practice guidelines for avian monitoring and impact mitigation at proposed wind energy development sites in southern Africa,” A Rep. BirdLife South Africa Endanger. Wildl. Trust, vol. 2, 2011.

M. Troselj, D. Fanton, M. Trošelj, and D. Fanton, “Computerization and the importance of informahon in health system, as in Health Care Resources Registry,” Acta Medica Croat., vol. 59, no. 3, 2005.

J. Li, C. Wu, P. K. Chu, and M. Gelinsky, “3D printing of hydrogels: Rational design strategies and emerging biomedical applications,” Materials Science and Engineering R: Reports, vol. 140. 2020, doi: 10.1016/j.mser.2020.100543.

B. M. Hsu, “Braille recognition for reducing asymmetric communication between the blind and non-blind,” Symmetry (Basel)., vol. 12, no. 7, 2020, doi: 10.3390/SYM12071069.

I. V. Choirony, M. S. Hariyanto, J. R. Telang, K. Kamal, K. Bangkalan, and J. Timur, “Achmad Ubaidillah 4) , Haryanto 5) dan Riza Alfita 6) 1), 2), 3), 4), 5), 6) Teknik Elektro, Fakultas Teknik,” Univ. Trunojoyo Madura, vol. 13, no. 1, pp. 13–21, 2021.

J. Davidovits, “Global warming impact on the cement and aggregates industries,” World Resour. Rev., vol. 6, no. 2, pp. 263–278, 1994.

A. Faizal et al., “MINI-REVIEW + HDOWK % HQHÀWV RI Moringa oleifera,” Int. J. Mol. Sci., 2014, doi: 10.7314/APJCP.2014.15.20.8571.

L. R. Roque, G. P. Morgado, V. M. Nascimento, J. L. Ienczak, and S. C. Rabelo, “Liquid-liquid extraction: A promising alternative for inhibitors removing of pentoses fermentation,” Fuel, 2019, doi: 10.1016/j.fuel.2018.12.130.

M. Nurtanto, S. D. Ramdani, and S. Nurhaji, “CHARACTERISTICS AND CONSUMPTION OF FUEL OIL SOLAR OIL WITH HAZELNUT OIL IN DIESEL MOTOR,” VANOS J. Mech. Eng. Educ., vol. 2, no. 2, Dec. 2017, doi: 10.30870/VANOS.V2I2.2926.




DOI: https://doi.org/10.52088/ijesty.v4i3.795

Article Metrics

Abstract view : 0 times
PDF - 0 times

Refbacks

  • There are currently no refbacks.


Copyright (c) 2025 Resep Sembiring, Immanuel Munthe, Adnan Surbakti, Tinus Ginting, Sabar Pasaribu

International Journal of Engineering, Science and Information Technology (IJESTY) eISSN 2775-2674